#INSTALL GEANY RASPBERRY PI INSTALL#

That should give you some confidence that it’s working OK. Run the gpio command to check the installation: gpio -v Remmeber the actual filename will be different – you will have to check the name and adjust accordingly.

You then need to do this to install: tar xfz Note that the numbers and letters after wiringPi (98bcb20 in this case) will probably be different – they’re a unique identifier for each release. This will download a tar.gz file with a name like. Then look for the link marked snapshot at the right-hand side.

#INSTALL GEANY RASPBERRY PI INSTALL#

The new build script will compile and install it all for you – it does use the sudo command at one point, so you may wish to inspect the script before running it.Ĭlick on this URL: (it should open in a new page) To build/install there is a new simplified script: cd wiringPi Will fetch an updated version then you can re-run the build script below. If you have already used the clone operation for the first time, then cd wiringPi To obtain WiringPi using GIT: git clone git:///wiringPi If you get any errors here, make sure your Pi is up to date with the latest versions of Raspbian: sudo apt-get update Raspbian), you can install it with: sudo apt-get install git-core If you do not have GIT installed, then under any of the Debian releases (e.g. WiringPi is now maintained under GIT for ease of change tracking, however there is a Plan B if you’re unable to use GIT for whatever reasons (usually your firewall will be blocking you, so do check that first!)

Install geany raspberry pi